Even if you're mixing yourself, it's better to add EQ and compression only when you can hear how it will sit with the soundtrack or special effects. Ultimately, it comes down to knowing what your voice will be used for and making a judgement. For instance, if I'm recording a tagline for a TV or radio advert, I'll generally run a mic into a nice preamp (where I might add slight tube warmth, and subtle EQ or compression, just to give the recording a bit of 'body'), and I may do a little de‑essing using a plug‑in when performing any edits. However, for e‑learning jobs, corporate videos and so on, I'll tend not to add any creative processing while recording or editing, and will only use the de‑esser ever so slightly.
As I've mentioned, most of our clients prefer to do post‑production work themselves, and request the raw (but edited) recordings. Sometimes, though, as in the Avast! job, the client will want the files ready to go, which might mean using slight EQ and compression. The noise floor on my recordings generally hovers around ‑54dB, but by using EQ to roll off frequencies below 80Hz and above 12kHz, I am usually able to lower the noise floor to around ‑57dB without resorting to noise reduction. Using EQ to reduce low‑end rumble and high‑frequency noise will make your recording sound better, and will be particularly beneficial if you'll be adding compression later, as the compressor's make-up gain won't be raising the level of that noise. Used moderately, compression can usefully reduce dynamic range, and thus improve intelligibility of the words, while still leaving you with a natural‑sounding result. Used excessively, it will suck the life out of a recording.
One of the most important rules is to ensure you value yourself as a professional. If you undervalue your own service it can be hard to later charge for the correct rates. A professional voice-over should cost a minimum amount, even if you’re new. If you allow clients to low-ball your work from the outset it will continue to set the expectation that they can get a voiceover from you on the cheap. This can then mean the difference between making a living and paying bills or not.

Hiring a voice actor can be intimidating, especially if you have not done it before. After all, the voice that reads your script is the most powerful connector you have with your audience — the voice quality brings emotion and a sensory experience to your video. Here are a few guidelines to managing your search and relationship with voice over talent.
Our recommendation is to start small and reinvest the money you make into upgrading your equipment and set up. All clients, whether they are Pixar or just a guy who needs a voicemail message, expect crystal clear audio recordings. You absolutely MUST be recording in a professional recording environment with professional equipment. They are NOT going to settle for less than perfection. Does this mean spending thousands of dollars? Maybe, eventually it does, but not today. What you’ll need to get started:
"The editing process for all our titles starts with receiving the Pro Tools sessions or WAV files and the engineer's script, which has the markings of how many takes there were, and which ones the director liked best. In some cases, I use Strip Silence and add a bed of room tone to expedite the assembly edit. In others I'll add the room tone as I move through the audio. Once I had all the final takes to be used in [Favorite African Folk Tales], I went back to do a fine‑edit pass and created notes on any issues, such as misreads, mispronunciations, noises, and so on. With that list, I was able to discuss with Alfre how we would address the issues. Since the actors' schedules did not permit them to come back in to do pick‑ups I had to do some creative editing.”
You need to appreciate that there is a lot to learn and do before your first paid voice acting job. Yes, you want to get out there and start auditioning. But first, you’re going to need proper training, equipment, resources, and yes, some natural talent. The great news is that even though the voice over industry is competitive, there is plenty of voice over work out there for everyone. This guide on how to become a voice actor will give you a good idea of where to start.
If a client likes your demo, they may invite you to audition. In the 21st century, you can download the audition script, record the audition at home, and then send the results to your client over the Internet. Prepare yourself for a life of constant auditions: Even successful voice pros may do many more auditions than actual jobs. But if enough jobs come your way, it's worth it.
The contents of this article are subject to worldwide copyright protection and reproduction in whole or part, whether mechanical or electronic, is expressly forbidden without the prior written consent of the Publishers. Great care has been taken to ensure accuracy in the preparation of this article but neither Sound On Sound Limited nor the publishers can be held responsible for its contents. The views expressed are those of the contributors and not necessarily those of the publishers.
×