I use the Adobe Audition package to edit my own voiceover work, but the techniques described below can be used in most audio‑editing software. Start by saving a new version of your original recording. (I keep the name of the file the same, but change the extension from _original to _edit.) Next, I'll turn my attention to the end of the recording, where I stepped away from the mic after the second take and recorded about 10 seconds of silence. Although processing is usually kept to a minimum, dealing with sibilance is important, and Eiosis' De‑esser plug‑in is much more precise than most.Wearing headphones, I can zoom in on this 'silence', turn up the volume, and listen for any background noise. If I notice any constant noise seeping into the recording, I may consider using Adobe Audition's noise‑reduction tool to capture a one‑ or two‑second profile of the silence, and then reduce the offending noise by about 75 percent throughout the recording. I should stress that this is rarely needed, and it's always a last resort, because such processing can generate swirly, metallic artifacts that draw more attention to themselves than the noise you intended to eliminate! But it's good to listen for such issues with fresh ears at the start of your editing session. If you find yourself using noise‑reduction often, that's a sign that you should find a better place to record, or improve the isolation of the space you've chosen. Don't forget that there are other ways to deal with some noise: often, a high‑pass filter is all you will need to clean up a recording, for example. Also remember that if your recording is to be mixed with music, slight background noise won't be noticeable, and that the more exposed your voice in the end product, the more problematic noise will become.
You will never have to answer to a “boss”, but you will need to be your own boss and manage yourself. You will work on your own a lot of the time. So you need to embrace the benefits and the challenges this presents. Take courses in areas where you need to develop your skills. When you adequately prepare for running a business, you will succeed in its management, even if part of managing your business means hiring out, in areas that you know are not your strongest.
At this point — unless you're tracking for broadcast applications (where they don't work to peak levels) — consider 'normalising' your recording to an optimal level. Normalisation can be used to push the loudest peak to around ‑1dB and increase the volume of the entire recording by the same ratio. Of course, you can also tighten up dynamic range (the difference between the softest and loudest parts of your recording) by manually reducing the loudest sections of the recording before you apply normalisation. On a final note, if you do plan to use a compressor, then you might as well add gain at that stage instead of normalising.
Congratulations! You should now have a finished voiceover recording. Save a final copy with the extension _master and use this version to save another copy in the format requested by the client. But don't think your job is done when you hand everything back to your producer‑self. Running a profitable home‑based voiceover business takes more than building and equipping a home studio and recording and editing audio files. You still have to design a web site, launch a marketing campaign, and secure new clients — all of which is something we'll look at another time.
"Ideally the talent should be seated, staying on axis, approximately a foot away from the mic, which should be angled back from the face a bit, not parallel to it. You'll need to see what angle provides the best results, usually a few degrees off from parallel works great — and located between the forehead and the nose, not directly in line with the mouth. This will help with plosives, mouth noise, and some other issues. Movement in the booth should be limited, as the microphone is likely to pick up arms flailing, hands rubbing, page turns, stomach growling, and so on. Keep the levels consistent, moving closer if the scene calls for a whisper, or moving back for a loud voice or scream. A well‑versed narrator is capable of delivering a dynamic performance without creating dynamic levels.”
Even if you're mixing yourself, it's better to add EQ and compression only when you can hear how it will sit with the soundtrack or special effects. Ultimately, it comes down to knowing what your voice will be used for and making a judgement. For instance, if I'm recording a tagline for a TV or radio advert, I'll generally run a mic into a nice preamp (where I might add slight tube warmth, and subtle EQ or compression, just to give the recording a bit of 'body'), and I may do a little de‑essing using a plug‑in when performing any edits. However, for e‑learning jobs, corporate videos and so on, I'll tend not to add any creative processing while recording or editing, and will only use the de‑esser ever so slightly.
Not all noise can be tackled in this way, though: you need to listen for clicks, plosives, digital glitches and the like. These can normally be acceptably repaired by using a 'heal' tool, or a pencil tool to redraw the waveform. Popped 'p's can often be 'fixed' using a high‑pass filter set at 100Hz. For a single glitch, you can zoom in and cut out the cycle of the waveform in which the glitch appears. Just be careful to start and end the cut where the waveform crosses the centre line, otherwise you'll inadvertently add another digital glitch. If glitches are frequent, it's likely that there's a problem with your audio interface's buffer settings — it may be just a playback issue.
Once you’ve identified a pool of candidates based on skills and availability, look at their experience and browse their gig gallery. Listen to samples of previous voice-over work to get a sense of their style, and choose the candidate whose style you like best. You can contact them before ordering, explain your project requirements, expectations, and budget, and provide examples of work you like by the seller or someone else as an audio reference.
Hiring a voice actor can be intimidating, especially if you have not done it before. After all, the voice that reads your script is the most powerful connector you have with your audience — the voice quality brings emotion and a sensory experience to your video. Here are a few guidelines to managing your search and relationship with voice over talent.
Fortunately, the internet has made this easier and more open. Most businesses have a logo, brand and a website. This forms the basis of how people get to know them. As a voice-over business you need to recognise that you need to market yourself. This involves ensuring you get your brand, your business, in front of the right people. Marketing though is also about building relationships with customers, not just selling to them. The more customers that use you on a regular basis the more money you can earn and the easier it becomes to achieve a good income.
You need to appreciate that there is a lot to learn and do before your first paid voice acting job. Yes, you want to get out there and start auditioning. But first, you’re going to need proper training, equipment, resources, and yes, some natural talent. The great news is that even though the voice over industry is competitive, there is plenty of voice over work out there for everyone. This guide on how to become a voice actor will give you a good idea of where to start.
The quality of your voice over depends almost entirely o the skill of the voice actor you use. A good voice actor will have perfect enunciation (ie, be very easy to understand), speak at an ideal pace (not too fast and not too slow), and have a pleasing voice. They should also be good at acting, and able to convey the feeling or emotions required by the script, using vocal variance and tone to keep the words interesting while also embodying the desired mood.
Finally, as you complete more work, you can end up with a lot of different files from your projects, so good 'housekeeping' of your sessions and recordings is a must. Glancing at the filename simone_kliass_avast_virus_database_neumann_tlm_103_original.wav, I can easily tell that this is the original recording of my wife's "Your virus database has been updated” message in Portuguese for Avast! on a Neumann TLM103 mic. It doesn't matter what your system is, as long as it works and you can stick to it.
When asked by someone outside of the industry how much I’m compensated for a commercial voice-over, I can see their eyes grow large with excitement. It may sound like a large number for two or three hours of studio time, but what is not understood is the investment in time, money and education that it takes to begin and sustain a voice acting career. As voice-over professionals, we need to remember (especially if we are setting our own rates) that the time we have spent in classes, coaching sessions, and our booth add up to our expertise in this field. When setting your own voice-over rates, or negotiating those set by producers and/or clients, you need to not only consider your session fee (the time spent in the booth recording the specific copy), but also all the training you’ve acquired and the investment in your home studio (which helps make your client’s job much easier).