Before you get down to the nitty-gritty, though, I recommend doing a test recording to ensure your equipment works properly and your audio levels are strong. You don’t need to record the entire script, but a few paragraphs will give you enough to ensure that the audio is clear, at an appropriate level, and doesn’t include any stray or ambient noises. 

Get your computer out of the room. Your microphone will pick up fan noise from your computer. Unless you have a solid state drive that is completely silent, you will want to set up a monitor in your studio and run cables through your wall to a computer outside the room. You can use a wireless keyboard and mouse to control your recording software. This also cuts down on the heat of your studio.
When asked by someone outside of the industry how much I’m compensated for a commercial voice-over, I can see their eyes grow large with excitement. It may sound like a large number for two or three hours of studio time, but what is not understood is the investment in time, money and education that it takes to begin and sustain a voice acting career. As voice-over professionals, we need to remember (especially if we are setting our own rates) that the time we have spent in classes, coaching sessions, and our booth add up to our expertise in this field. When setting your own voice-over rates, or negotiating those set by producers and/or clients, you need to not only consider your session fee (the time spent in the booth recording the specific copy), but also all the training you’ve acquired and the investment in your home studio (which helps make your client’s job much easier).

Also listen for sibilance. Strong 'ess' sounds are best corrected at source, by using good mic technique, but sometimes they're unavoidable. If you hear an 'ess' that really sizzles in your recording, you can manually reduce its volume. You can, of course, also use a de‑esser, but do be careful, as applying some de‑essers to the entire audio file can alter the sound of your recording. It often works best to apply them to short sections, either offline or using automation. My preferred de‑esser plug‑in is the one sold by Eiosis (,Make sure you record some silence at the end of each take. That way, if a great performance suffers from noise issues, you have something to feed your noise‑reduction processors. Just don't rely on this technique too much! which cleverly separates the esses from the rest of the audio and allows you to manipulate them independently. If you want to learn about some more advanced strategies for de‑essing check out Mike Senior's article from SOS May 2009 (/sos/may09/articles/deessing.htm).

Even if you're mixing yourself, it's better to add EQ and compression only when you can hear how it will sit with the soundtrack or special effects. Ultimately, it comes down to knowing what your voice will be used for and making a judgement. For instance, if I'm recording a tagline for a TV or radio advert, I'll generally run a mic into a nice preamp (where I might add slight tube warmth, and subtle EQ or compression, just to give the recording a bit of 'body'), and I may do a little de‑essing using a plug‑in when performing any edits. However, for e‑learning jobs, corporate videos and so on, I'll tend not to add any creative processing while recording or editing, and will only use the de‑esser ever so slightly.
If a client likes your demo, they may invite you to audition. In the 21st century, you can download the audition script, record the audition at home, and then send the results to your client over the Internet. Prepare yourself for a life of constant auditions: Even successful voice pros may do many more auditions than actual jobs. But if enough jobs come your way, it's worth it.

"You need to be able to pull the listener in, help them suspend disbelief, become a part of the world the author created, and take the journey with your voice as the guide. Practice your character voices; they must be believable and honest. Work on your accents and timing and delivery within different genres. When reading, read out loud — even if you're not recording or being paid for it. This will help you with flow and dialogue. Listen to other audiobooks and figure out what you like and don't like, then work on these factors in your own performances. Working from a home studio, you have many more responsibilities to consider. Be mindful of them, set attainable goals and know your limitations. Never over-promise and under-deliver to a client. There are many established and aspiring narrators out there, so bring your best to the table.”

As the engineer, your key job is to select and set up the recording space, choose and position the microphone, set levels and make sure you're recording a good, clean signal at a healthy level. Like music, the louder the signal you want to record, the less audible the noise floor, but you don't want to have to speak louder than sounds natural, and you don't want to overcook things when tracking: any distortion will be very noticeable on an exposed voice part, and an otherwise great take with digital clipping won't be acceptable. If you notice clipping only when you start editing, software clip restoration tools might help to make the take usable, but it's not going to be perfect. Remember that although you may have needed to record 'hot' on analogue tape and older 16‑bit digital recording systems, modern 24‑bit A‑D converters can accommodate a much wider dynamic range, so you no longer have to track so loud: you can leave much more headroom.
At this point — unless you're tracking for broadcast applications (where they don't work to peak levels) — consider 'normalising' your recording to an optimal level. Normalisation can be used to push the loudest peak to around ‑1dB and increase the volume of the entire recording by the same ratio. Of course, you can also tighten up dynamic range (the difference between the softest and loudest parts of your recording) by manually reducing the loudest sections of the recording before you apply normalisation. On a final note, if you do plan to use a compressor, then you might as well add gain at that stage instead of normalising.
Finally, as you complete more work, you can end up with a lot of different files from your projects, so good 'housekeeping' of your sessions and recordings is a must. Glancing at the filename simone_kliass_avast_virus_database_neumann_tlm_103_original.wav, I can easily tell that this is the original recording of my wife's "Your virus database has been updated” message in Portuguese for Avast! on a Neumann TLM103 mic. It doesn't matter what your system is, as long as it works and you can stick to it. 

3. You need a simple, reliable, home-recording setup. Keep in mind: Your objective is on being the best voice talent you can be, not the best production studio or recording engineer. Nevertheless, you do need the ability to record, edit, and turnaround a proper audition. Do not run out and purchase a mic! You can’t return it, for hygienic reasons. Besides, there’s a bit of a learning curve to this and recent industry advances have made having a home “studio” easier and more affordable than ever before. You could have the best gear and the coolest toys on the block, but if you can’t use them it’s a waste. (Tip: What you’re recording on matters less than where you’re recording. Find a quiet place like a closet full of clothes to record in.)
This is the number-one issue most people bring up when they discover they have to do voice over work for their video. Let’s face it. Most of us rarely have to hear our own voices in audio recordings. We’re used to the rich, warm sound of our own voices in our own ears. There’s no way around the fact that you sound different on recording that you do to yourself.
When considering “how much do voice actors make”, you have to consider the physical demands of the job. A voiceover actor’s main tool is their voice. Unlike a machine, the voice is a sensitive instrument and cannot be used to extremes all day, every day. If you did, you would risk damaging your vocal chords. Of course delivering the same consistent quality 12 hours a day would also be impossible. For many established voiceover talent, even long periods of use, 3-4 hours at a stretch can be tiring. At the extreme vocal end of voice acting you have gaming. In gaming the physicality of shouting and using the full range of voice, often for different characters takes it’s toll. For this reason many gaming voice actors are particularly careful about their vocal health.
If a client likes your demo, they may invite you to audition. In the 21st century, you can download the audition script, record the audition at home, and then send the results to your client over the Internet. Prepare yourself for a life of constant auditions: Even successful voice pros may do many more auditions than actual jobs. But if enough jobs come your way, it's worth it.
Always update yourself on industry standard rates. I recommend reviewing the union rates set forth by SAG-AFTRA. also offers a rate card as well Voice-Over Resource Guide. Upon viewing these rates you may find, based on your current experience, you fall a little lower or higher than said rates. Maybe you have a great deal of experience in the commercial voice-over world, but now you’re branching out into narration, e-learning or audiobooks, so your voice-over rates may be a bit lower for that genre as you find your footing. The most important thing is that you have a baseline rate for yourself and you’re comfortable and confident stating this rate to a client. It’s beneficial to first ask your client’s budget and proceed from there. While stating your rate, also take into consideration edits and pick-ups. It’s customary to include one free round of edits in your rate, but any edits or pick-ups past that incur a fee.