I thought keeping recording levels in daw to -12 was reccomended I saw when doing voice overs I saw somewhere on youtube? Is -18 or -15 a better volume to keep it at when recording voice overs? I use an external preamp then going into my audio interface. I always thought it is better not to add amplify on the daw but to do as much as possible to get that clean gain from your audio interface and or preamp. In general when doing reads is -18 really a good level to record voice overs and just leave it at that when done or should you amplify it afterwards? If this is right maybe I should start recording in -18 or at very least -15 in the daw software?
Next, run these files through any standard EQ high‑pass and low‑pass filters you use, zoom in on the waveform, and select a one‑second strip of silence from each recording. Save these strips as separate files. For instance, on my system, a one‑second strip of silence recorded at 16‑bit, 44.1kHz on a Neumann TLM103 would have this name: room_tone_neumann_tlm_103_44100_16_one_second.wav. Ideally, the noise floor of each strip will be lower than ‑60dB. Now, when you have to remove a bump or a squeak between words, you can paste in a piece of these strips instead of muting, which would draw attention to the edit. 

Voiceover-Services.com welcomes you to listen & consider professional voice actor Paul Fraley for your next campaign or project. Located in Los Angeles, Paul brings an excitement & unique point-of-view to his work. Whether voicing National TV commercials, explainer videos, creating character voices for international video game apps or as the signature voice for a mid-west grocery store chain – Paul always looks forward to telling the next story.
×