"When recording voiceovers at home, you have to focus on performance: keep your energy levels up, stay true to the page, pronounce words correctly and consistently, and make sure you keep to a schedule to make the deadline. Prep well so you don't waste time second‑guessing yourself, looking up words as you go, and remember to not over‑ or under‑direct yourself. Also, make sure you know your recording equipment and room well; being able to quickly make adjustments to mic placement, levels, and so on, will make you more efficient.”

I use the Adobe Audition package to edit my own voiceover work, but the techniques described below can be used in most audio‑editing software. Start by saving a new version of your original recording. (I keep the name of the file the same, but change the extension from _original to _edit.) Next, I'll turn my attention to the end of the recording, where I stepped away from the mic after the second take and recorded about 10 seconds of silence. Although processing is usually kept to a minimum, dealing with sibilance is important, and Eiosis' De‑esser plug‑in is much more precise than most.Wearing headphones, I can zoom in on this 'silence', turn up the volume, and listen for any background noise. If I notice any constant noise seeping into the recording, I may consider using Adobe Audition's noise‑reduction tool to capture a one‑ or two‑second profile of the silence, and then reduce the offending noise by about 75 percent throughout the recording. I should stress that this is rarely needed, and it's always a last resort, because such processing can generate swirly, metallic artifacts that draw more attention to themselves than the noise you intended to eliminate! But it's good to listen for such issues with fresh ears at the start of your editing session. If you find yourself using noise‑reduction often, that's a sign that you should find a better place to record, or improve the isolation of the space you've chosen. Don't forget that there are other ways to deal with some noise: often, a high‑pass filter is all you will need to clean up a recording, for example. Also remember that if your recording is to be mixed with music, slight background noise won't be noticeable, and that the more exposed your voice in the end product, the more problematic noise will become.
We screen our talents to make sure your voice recording has a professional broadcast quality level. Once you order a project, your money is absolutely safe with us. We do not pay the voiceover artist until the project is successfully done and approved by you. You can asks for revisions at no extra cost as long as they don't involve changes in the script.
The quality of your voice over depends almost entirely o the skill of the voice actor you use. A good voice actor will have perfect enunciation (ie, be very easy to understand), speak at an ideal pace (not too fast and not too slow), and have a pleasing voice. They should also be good at acting, and able to convey the feeling or emotions required by the script, using vocal variance and tone to keep the words interesting while also embodying the desired mood.
First of all, don’t be put off by the word technical. The ‘technical’ skills you need to learn to involve how you record and then edit your recording and of course you will need a home studio to do this. This needn’t be a daunting prospect though. Many freelance sound engineers are available who can help you with this – contact us if you want a reputable one.
"Ideally the talent should be seated, staying on axis, approximately a foot away from the mic, which should be angled back from the face a bit, not parallel to it. You'll need to see what angle provides the best results, usually a few degrees off from parallel works great — and located between the forehead and the nose, not directly in line with the mouth. This will help with plosives, mouth noise, and some other issues. Movement in the booth should be limited, as the microphone is likely to pick up arms flailing, hands rubbing, page turns, stomach growling, and so on. Keep the levels consistent, moving closer if the scene calls for a whisper, or moving back for a loud voice or scream. A well‑versed narrator is capable of delivering a dynamic performance without creating dynamic levels.”
The annual income of a voice talent varies greatly from person to person and from year to year. When you’re just starting out most of what you earn from voice over work should be reinvested into your studio, demos, and marketing efforts, so at this stage you will need a second job to support your daily living expenses. Once you start building a portfolio of clients, you’ll see your regular earnings grow and will really start to get a feel for the potential your voice over business has. In time, you’ll be enjoying a satisfying career.
A great performance recorded on mediocre gear will always sound better than a mediocre performance recorded on great gear. By preparing well, before the session, you'll find it far easier to relax and focus on the message and the listener. As a producer, it's important to be clear what the expected format is for the final audio file. Although there are certain 'standards', your clients' expectations will vary.Read through the script, look up any questionable words and check their pronunciation. For American English, which accounts for the majority of my work, my favourite pronunciation resource is the Merriam‑Webster on‑line dictionary (www.m‑w.com), which includes audio examples. If you don't know how to pronounce the name of a company or product, call the company's customer service centre (if anyone can pronounce it right, they can!). If you don't know how to pronounce the name of a person or city, try searching YouTube for news reports on the subject.
At this point — unless you're tracking for broadcast applications (where they don't work to peak levels) — consider 'normalising' your recording to an optimal level. Normalisation can be used to push the loudest peak to around ‑1dB and increase the volume of the entire recording by the same ratio. Of course, you can also tighten up dynamic range (the difference between the softest and loudest parts of your recording) by manually reducing the loudest sections of the recording before you apply normalisation. On a final note, if you do plan to use a compressor, then you might as well add gain at that stage instead of normalising.

Recording voice overs like a pro isn’t that difficult when you know how to do it. You may have noticed that the actual recording part plays little part when compared to the preparation. Taking the proper steps before you hit the record button and then taking the time to edit your audio appropriately will go a long way to ensuring your voice overs sound professional and engaging.
"Ideally the talent should be seated, staying on axis, approximately a foot away from the mic, which should be angled back from the face a bit, not parallel to it. You'll need to see what angle provides the best results, usually a few degrees off from parallel works great — and located between the forehead and the nose, not directly in line with the mouth. This will help with plosives, mouth noise, and some other issues. Movement in the booth should be limited, as the microphone is likely to pick up arms flailing, hands rubbing, page turns, stomach growling, and so on. Keep the levels consistent, moving closer if the scene calls for a whisper, or moving back for a loud voice or scream. A well‑versed narrator is capable of delivering a dynamic performance without creating dynamic levels.”

As the engineer, your key job is to select and set up the recording space, choose and position the microphone, set levels and make sure you're recording a good, clean signal at a healthy level. Like music, the louder the signal you want to record, the less audible the noise floor, but you don't want to have to speak louder than sounds natural, and you don't want to overcook things when tracking: any distortion will be very noticeable on an exposed voice part, and an otherwise great take with digital clipping won't be acceptable. If you notice clipping only when you start editing, software clip restoration tools might help to make the take usable, but it's not going to be perfect. Remember that although you may have needed to record 'hot' on analogue tape and older 16‑bit digital recording systems, modern 24‑bit A‑D converters can accommodate a much wider dynamic range, so you no longer have to track so loud: you can leave much more headroom.
Our recommendation is to start small and reinvest the money you make into upgrading your equipment and set up. All clients, whether they are Pixar or just a guy who needs a voicemail message, expect crystal clear audio recordings. You absolutely MUST be recording in a professional recording environment with professional equipment. They are NOT going to settle for less than perfection. Does this mean spending thousands of dollars? Maybe, eventually it does, but not today. What you’ll need to get started:

In other words, Mirek gave us all the information we needed to start the job. Unfortunately, though, that's not how it usually works! Usually, you'll need to work hard to get all the information you need from your client to do the job well. If you're at all uncertain about their expectations, whether about the performance, or about technical and organisational issues such as file formats or payment procedures, save yourself time and a headache by clearing up all doubts beforehand, and don't hit the record button until your client has given you the green light by email. With that sorted, you can more easily don your other hats and get on with the job.


Voice over is a production technique where a voice that is not part of the narrative is heard over the action. It’s often used in movies, TV shows, plays, or other presentations. Voice over is an effective way to convey information that doesn’t naturally fit into the plot or the other visual elements that are occurring. Voice over work is read by a voice actor who reads from a script, and it is added to the other elements during production.
3. You need a simple, reliable, home-recording setup. Keep in mind: Your objective is on being the best voice talent you can be, not the best production studio or recording engineer. Nevertheless, you do need the ability to record, edit, and turnaround a proper audition. Do not run out and purchase a mic! You can’t return it, for hygienic reasons. Besides, there’s a bit of a learning curve to this and recent industry advances have made having a home “studio” easier and more affordable than ever before. You could have the best gear and the coolest toys on the block, but if you can’t use them it’s a waste. (Tip: What you’re recording on matters less than where you’re recording. Find a quiet place like a closet full of clothes to record in.)
Voiceover-Services.com welcomes you to listen & consider professional voice actor Paul Fraley for your next campaign or project. Located in Los Angeles, Paul brings an excitement & unique point-of-view to his work. Whether voicing National TV commercials, explainer videos, creating character voices for international video game apps or as the signature voice for a mid-west grocery store chain – Paul always looks forward to telling the next story.
Even if you're mixing yourself, it's better to add EQ and compression only when you can hear how it will sit with the soundtrack or special effects. Ultimately, it comes down to knowing what your voice will be used for and making a judgement. For instance, if I'm recording a tagline for a TV or radio advert, I'll generally run a mic into a nice preamp (where I might add slight tube warmth, and subtle EQ or compression, just to give the recording a bit of 'body'), and I may do a little de‑essing using a plug‑in when performing any edits. However, for e‑learning jobs, corporate videos and so on, I'll tend not to add any creative processing while recording or editing, and will only use the de‑esser ever so slightly.
© 2020 GoAnimate, Inc. All Rights Reserved. VYOND™ is a trademark of GoAnimate, Inc., registered in Australia, Brazil, Chile, the European Union, Hong Kong, India, Israel, Mexico, New Zealand, Norway, OAPI, the Philippines, Singapore, Switzerland, the United Kingdom, and Vietnam; Reg. U.S. Pat. & Tm. Off. Other names and marks are the property of their respective holders.
At this point — unless you're tracking for broadcast applications (where they don't work to peak levels) — consider 'normalising' your recording to an optimal level. Normalisation can be used to push the loudest peak to around ‑1dB and increase the volume of the entire recording by the same ratio. Of course, you can also tighten up dynamic range (the difference between the softest and loudest parts of your recording) by manually reducing the loudest sections of the recording before you apply normalisation. On a final note, if you do plan to use a compressor, then you might as well add gain at that stage instead of normalising.
×