Not all noise can be tackled in this way, though: you need to listen for clicks, plosives, digital glitches and the like. These can normally be acceptably repaired by using a 'heal' tool, or a pencil tool to redraw the waveform. Popped 'p's can often be 'fixed' using a high‑pass filter set at 100Hz. For a single glitch, you can zoom in and cut out the cycle of the waveform in which the glitch appears. Just be careful to start and end the cut where the waveform crosses the centre line, otherwise you'll inadvertently add another digital glitch. If glitches are frequent, it's likely that there's a problem with your audio interface's buffer settings — it may be just a playback issue.

You start off each job as a producer, consulting your client and getting briefed on the project at hand. Then you become an engineer, dealing with recording gear and software, setting the mic position and levels. Next, you step up to the mic as an actor, bringing the script off the page and connecting with the listener. Meanwhile, the director in you sits behind the metaphorical glass, making sure the actor doesn't mispronounce a word or stumble through a passage of text. Then you're an editor, cleaning up the best take and sending the resulting audio to your client. You need to be able to perform all of these roles to a high standard, and the better you are at each, the more your business will prosper.
It's only after this sort of processing that I'll start cleaning up the recording and dealing with the gaps of silence between spoken passages. A noise gate (or an off‑line 'strip‑silence' function) can be used to automatically mute sections that fall below a certain level. However, if not used carefully, these tools will clip the 'T's and 'P's off the ends of words, and shut out natural breathing sounds. Worse, if your recording is noisy, a noise gate will actually draw attention to the problem, since your client will be able to hear the difference between room tone and absolute muting. Another trick is to use a downward expander to reduce the noise floor of quiet sections, rather than cut out the noise completely.
I thought keeping recording levels in daw to -12 was reccomended I saw when doing voice overs I saw somewhere on youtube? Is -18 or -15 a better volume to keep it at when recording voice overs? I use an external preamp then going into my audio interface. I always thought it is better not to add amplify on the daw but to do as much as possible to get that clean gain from your audio interface and or preamp. In general when doing reads is -18 really a good level to record voice overs and just leave it at that when done or should you amplify it afterwards? If this is right maybe I should start recording in -18 or at very least -15 in the daw software?
Before you get down to the nitty-gritty, though, I recommend doing a test recording to ensure your equipment works properly and your audio levels are strong. You don’t need to record the entire script, but a few paragraphs will give you enough to ensure that the audio is clear, at an appropriate level, and doesn’t include any stray or ambient noises.
How much do voice actors make? There is of course no simple answer to this. What you get paid as a voice actor will depend on the type of work, size of project, your experience and many other factors. Some voice actors who are also movie stars, are worth millions. Others, who use freelancing sites can make as little as $30 for a simple radio commercial in a small market. Most professional voice actors fall in between.

A great performance recorded on mediocre gear will always sound better than a mediocre performance recorded on great gear. By preparing well, before the session, you'll find it far easier to relax and focus on the message and the listener. As a producer, it's important to be clear what the expected format is for the final audio file. Although there are certain 'standards', your clients' expectations will vary.Read through the script, look up any questionable words and check their pronunciation. For American English, which accounts for the majority of my work, my favourite pronunciation resource is the Merriam‑Webster on‑line dictionary (www.m‑w.com), which includes audio examples. If you don't know how to pronounce the name of a company or product, call the company's customer service centre (if anyone can pronounce it right, they can!). If you don't know how to pronounce the name of a person or city, try searching YouTube for news reports on the subject.


Some clients are not experienced in voice over. So another way you can help them is to advice then and help them really understand all that goes into a voice over recording to get it to the final polished result. Of course you need to take this into account when you charge for your time and again whether this is a one off project or has potential to be a long term client.
Some might think that the audio portion of a video takes a backseat to the visual portions, but that’s not true. Most video watchers note that they are more likely to stop watching a video with bad audio vs. lower-quality video. In fact, a recent TechSmith study of video viewing habits showed that more than 25% of video viewers watched a video all the way through because the audio was good — more than those who said professional video style was most important.
Hiring a voice actor can be intimidating, especially if you have not done it before. After all, the voice that reads your script is the most powerful connector you have with your audience — the voice quality brings emotion and a sensory experience to your video. Here are a few guidelines to managing your search and relationship with voice over talent.
First, I like to listen to the entire voice over recording from start to finish. I may make notes here and there to remind myself of something I want to go back and edit, but this time through I really just want to concentrate on the overall pacing and tone of the recording. Does it sound like I hoped? Did I rush or speak too slowly? Did I flub any words, mumble, or misspeak? Are there weird silences or unknown sounds?
Both union and non-union have advantages and disadvantages; ultimately, it’s a decision that you, as a voice over actor, will have to make. Like everything else, it’s of critical importance that you do your research and weigh up the pros and cons. Seasoned pros will usually tell you it’s best to be a union member because, if you run into trouble, the union will fight your cause.
Before you get down to the nitty-gritty, though, I recommend doing a test recording to ensure your equipment works properly and your audio levels are strong. You don’t need to record the entire script, but a few paragraphs will give you enough to ensure that the audio is clear, at an appropriate level, and doesn’t include any stray or ambient noises.
The annual income of a voice talent varies greatly from person to person and from year to year. When you’re just starting out most of what you earn from voice over work should be reinvested into your studio, demos, and marketing efforts, so at this stage you will need a second job to support your daily living expenses. Once you start building a portfolio of clients, you’ll see your regular earnings grow and will really start to get a feel for the potential your voice over business has. In time, you’ll be enjoying a satisfying career.
Perhaps you come from a corporate business background, but you have a remarkable capacity for accents and original character voices, or you’ve been in radio and broadcasting for a number of years. If you’re an actor looking to expand your employment opportunities, mastering voiceover is imperative considering it’s required in every manner of recorded media: film, TV, animation, games, corporate industrials, and commercials. Whatever your specific experience has been to date, getting started in voiceover most often requires the following:
You start off each job as a producer, consulting your client and getting briefed on the project at hand. Then you become an engineer, dealing with recording gear and software, setting the mic position and levels. Next, you step up to the mic as an actor, bringing the script off the page and connecting with the listener. Meanwhile, the director in you sits behind the metaphorical glass, making sure the actor doesn't mispronounce a word or stumble through a passage of text. Then you're an editor, cleaning up the best take and sending the resulting audio to your client. You need to be able to perform all of these roles to a high standard, and the better you are at each, the more your business will prosper.
Next, run these files through any standard EQ high‑pass and low‑pass filters you use, zoom in on the waveform, and select a one‑second strip of silence from each recording. Save these strips as separate files. For instance, on my system, a one‑second strip of silence recorded at 16‑bit, 44.1kHz on a Neumann TLM103 would have this name: room_tone_neumann_tlm_103_44100_16_one_second.wav. Ideally, the noise floor of each strip will be lower than ‑60dB. Now, when you have to remove a bump or a squeak between words, you can paste in a piece of these strips instead of muting, which would draw attention to the edit.
You need to appreciate that there is a lot to learn and do before your first paid voice acting job. Yes, you want to get out there and start auditioning. But first, you’re going to need proper training, equipment, resources, and yes, some natural talent. The great news is that even though the voice over industry is competitive, there is plenty of voice over work out there for everyone. This guide on how to become a voice actor will give you a good idea of where to start.
In late 2009, my wife Simone received an email from Prague in the Czech Republic. The sender, Mirek Jirku, was heading up a project to record voice messages for the foreign‑language versions of the latest Avast! anti‑virus software. Mirek sent us eight messages to be recorded, specified the fee and deadline, and requested a slow, friendly read. He asked us to send separate stereo MP3 files (at 160kbps or higher quality) for each message, specified that we'd have to sign a non‑disclosure agreement before recording, that we'd need to invoice afterwards, and that he'd pay via a wire transfer instead of PayPal (which is often used for international payments).
Next, go back to the beginning and start editing out your mistakes. I also like to edit out any abnormally long silences between sentences or statements and any weird sounds that don’t belong. Remember, though, that pauses are ok (and even necessary) to help break up the audio and make it feel more natural and conversational, so don’t go hog wild with it.
Voice actors get paid on a per project or per job basis. Your earnings as a voice actor range from: $35 for a small market radio spot, $150 for a 15 second recording for say a small website, $250 – $350 for a 30 second major market radio commercial (Plus use fees) to about $2000 – $5000 per audiobook, as an established voice talent. There are several ways to calculate how much voice actors get paid, with the most common being the word count of the script. The use of the material is also taken into consideration and whether or not you are granting a license to use your material for a specific duration on specific channels or if you are seeking a fee for a universal buyout.
3. You need a simple, reliable, home-recording setup. Keep in mind: Your objective is on being the best voice talent you can be, not the best production studio or recording engineer. Nevertheless, you do need the ability to record, edit, and turnaround a proper audition. Do not run out and purchase a mic! You can’t return it, for hygienic reasons. Besides, there’s a bit of a learning curve to this and recent industry advances have made having a home “studio” easier and more affordable than ever before. You could have the best gear and the coolest toys on the block, but if you can’t use them it’s a waste. (Tip: What you’re recording on matters less than where you’re recording. Find a quiet place like a closet full of clothes to record in.)
"This was Alfre Woodard's audiobook directing debut, and she pulled an amazing performance from people. The big [thing] was to remember that these stories were being told in intimate settings, one‑on‑one in most cases, so the talent really needed to speak to the individual listener. An image kept in mind was stories being told around a campfire, back when folktales were passed down by spoken word.”

Some of you might be wondering about the difference between voice over and narration. The short answer: not much. In most cases, you may use voice over and narration fairly interchangeably. However, to be technically correct, narration typically refers to an audio vocal that describes all the action on screen or tells a story based on what’s happening, while voice over may or may not describe as much action and is often more instructional in nature.


Another factor to consider is how the project is being used and in which medium. If you record a commercial that’s airing nationally on television, then that is a larger rate than a regional television commercial specific to a certain market. The voice-over spot you worked on is being seen by more viewers nationally as opposed to regionally, which warrants more compensation. You should not only consider your session fee, but also get the specifics on how the voice-over is being used. My personal opinion is to avoid “in perpetuity” usage because as your career develops, something which was not a conflict in the past could be in the future. If the spot you had conflicts with another brand in which you are auditioning, this could become a conflict that was unforeseen when you initially booked and recorded the job.
"Ideally the talent should be seated, staying on axis, approximately a foot away from the mic, which should be angled back from the face a bit, not parallel to it. You'll need to see what angle provides the best results, usually a few degrees off from parallel works great — and located between the forehead and the nose, not directly in line with the mouth. This will help with plosives, mouth noise, and some other issues. Movement in the booth should be limited, as the microphone is likely to pick up arms flailing, hands rubbing, page turns, stomach growling, and so on. Keep the levels consistent, moving closer if the scene calls for a whisper, or moving back for a loud voice or scream. A well‑versed narrator is capable of delivering a dynamic performance without creating dynamic levels.”
If a client likes your demo, they may invite you to audition. In the 21st century, you can download the audition script, record the audition at home, and then send the results to your client over the Internet. Prepare yourself for a life of constant auditions: Even successful voice pros may do many more auditions than actual jobs. But if enough jobs come your way, it's worth it.
If a client likes your demo, they may invite you to audition. In the 21st century, you can download the audition script, record the audition at home, and then send the results to your client over the Internet. Prepare yourself for a life of constant auditions: Even successful voice pros may do many more auditions than actual jobs. But if enough jobs come your way, it's worth it.
You don't need a state-of-the-art production studio to work in voice-over. You do need good enough equipment to record, edit and submit a good audition. A computer with a microphone and a mixer may do the trick. It's important that the room you record in be as soundproof as possible – if you use a walk-in closet where the clothes muffle the sounds outside, the industry's not going to complain.
You need to appreciate that there is a lot to learn and do before your first paid voice acting job. Yes, you want to get out there and start auditioning. But first, you’re going to need proper training, equipment, resources, and yes, some natural talent. The great news is that even though the voice over industry is competitive, there is plenty of voice over work out there for everyone. This guide on how to become a voice actor will give you a good idea of where to start.
ADR / Automated Dialogue Replacement in Salt Lake City, Utah Audio Mixing / Sound Recording Equipment Rentals in Salt Lake City, Utah Audio Mixing / Sweetening / Sound Editing / Sound Designers in Salt Lake City, Utah Audio Technicians / Audio Engineer / A1 / A2 in Salt Lake City, Utah Film Post Production Services in Salt Lake City, Utah Foley Stages in Salt Lake City, Utah Post House / Video Post Production Facilities / Editing Services in Salt Lake City, Utah Recording Studios in Salt Lake City, Utah Sound Mixers / Recordists in Salt Lake City, Utah Voice Over Artists in Salt Lake City, Utah
×