You start off each job as a producer, consulting your client and getting briefed on the project at hand. Then you become an engineer, dealing with recording gear and software, setting the mic position and levels. Next, you step up to the mic as an actor, bringing the script off the page and connecting with the listener. Meanwhile, the director in you sits behind the metaphorical glass, making sure the actor doesn't mispronounce a word or stumble through a passage of text. Then you're an editor, cleaning up the best take and sending the resulting audio to your client. You need to be able to perform all of these roles to a high standard, and the better you are at each, the more your business will prosper.

Some might think that the audio portion of a video takes a backseat to the visual portions, but that’s not true. Most video watchers note that they are more likely to stop watching a video with bad audio vs. lower-quality video. In fact, a recent TechSmith study of video viewing habits showed that more than 25% of video viewers watched a video all the way through because the audio was good — more than those who said professional video style was most important.
At this point — unless you're tracking for broadcast applications (where they don't work to peak levels) — consider 'normalising' your recording to an optimal level. Normalisation can be used to push the loudest peak to around ‑1dB and increase the volume of the entire recording by the same ratio. Of course, you can also tighten up dynamic range (the difference between the softest and loudest parts of your recording) by manually reducing the loudest sections of the recording before you apply normalisation. On a final note, if you do plan to use a compressor, then you might as well add gain at that stage instead of normalising.

Before you get down to the nitty-gritty, though, I recommend doing a test recording to ensure your equipment works properly and your audio levels are strong. You don’t need to record the entire script, but a few paragraphs will give you enough to ensure that the audio is clear, at an appropriate level, and doesn’t include any stray or ambient noises.

Not all noise can be tackled in this way, though: you need to listen for clicks, plosives, digital glitches and the like. These can normally be acceptably repaired by using a 'heal' tool, or a pencil tool to redraw the waveform. Popped 'p's can often be 'fixed' using a high‑pass filter set at 100Hz. For a single glitch, you can zoom in and cut out the cycle of the waveform in which the glitch appears. Just be careful to start and end the cut where the waveform crosses the centre line, otherwise you'll inadvertently add another digital glitch. If glitches are frequent, it's likely that there's a problem with your audio interface's buffer settings — it may be just a playback issue.
Digital Commercials are defined as spots that are used to advertise a product or service that are run on websites or platforms other than the client's own. For example, a 15 second recording that plays on YouTube before the requested content begins. Explainer videos are not included in this rate, they fall into INTERNET USAGE / EXPLAINER in another category.
The contents of this article are subject to worldwide copyright protection and reproduction in whole or part, whether mechanical or electronic, is expressly forbidden without the prior written consent of the Publishers. Great care has been taken to ensure accuracy in the preparation of this article but neither Sound On Sound Limited nor the publishers can be held responsible for its contents. The views expressed are those of the contributors and not necessarily those of the publishers.
×