Your own voice is your most important piece of equipment. If you're new to the voice-acting world, look around to see if there are classes or coaching in your area. Outside of class, practice speaking clearly and confidently. Learn to do this even with material you've never seen before. It's also important to learn voice care – straining or injuring your voice can hurt you and your career.
Both union and non-union have advantages and disadvantages; ultimately, it’s a decision that you, as a voice over actor, will have to make. Like everything else, it’s of critical importance that you do your research and weigh up the pros and cons. Seasoned pros will usually tell you it’s best to be a union member because, if you run into trouble, the union will fight your cause.
As the engineer, your key job is to select and set up the recording space, choose and position the microphone, set levels and make sure you're recording a good, clean signal at a healthy level. Like music, the louder the signal you want to record, the less audible the noise floor, but you don't want to have to speak louder than sounds natural, and you don't want to overcook things when tracking: any distortion will be very noticeable on an exposed voice part, and an otherwise great take with digital clipping won't be acceptable. If you notice clipping only when you start editing, software clip restoration tools might help to make the take usable, but it's not going to be perfect. Remember that although you may have needed to record 'hot' on analogue tape and older 16‑bit digital recording systems, modern 24‑bit A‑D converters can accommodate a much wider dynamic range, so you no longer have to track so loud: you can leave much more headroom.
"You need to be able to pull the listener in, help them suspend disbelief, become a part of the world the author created, and take the journey with your voice as the guide. Practice your character voices; they must be believable and honest. Work on your accents and timing and delivery within different genres. When reading, read out loud — even if you're not recording or being paid for it. This will help you with flow and dialogue. Listen to other audiobooks and figure out what you like and don't like, then work on these factors in your own performances. Working from a home studio, you have many more responsibilities to consider. Be mindful of them, set attainable goals and know your limitations. Never over-promise and under-deliver to a client. There are many established and aspiring narrators out there, so bring your best to the table.”
There are lots of ways to get voice acting work, from online sites such as Bodalgo.com, Mandy.com, Voice123 and Voices.com. These are known as pay to play sites. They have lots of opportunities for you to audition, but it is highly competitive. Looking locally for businesses, including radio stations, that need voiceover is also a good way to start.
Our recommendation is to start small and reinvest the money you make into upgrading your equipment and set up. All clients, whether they are Pixar or just a guy who needs a voicemail message, expect crystal clear audio recordings. You absolutely MUST be recording in a professional recording environment with professional equipment. They are NOT going to settle for less than perfection. Does this mean spending thousands of dollars? Maybe, eventually it does, but not today. What you’ll need to get started:
The annual income of a voice talent varies greatly from person to person and from year to year. When you’re just starting out most of what you earn from voice over work should be reinvested into your studio, demos, and marketing efforts, so at this stage you will need a second job to support your daily living expenses. Once you start building a portfolio of clients, you’ll see your regular earnings grow and will really start to get a feel for the potential your voice over business has. In time, you’ll be enjoying a satisfying career.
We screen our talents to make sure your voice recording has a professional broadcast quality level. Once you order a project, your money is absolutely safe with us. We do not pay the voiceover artist until the project is successfully done and approved by you. You can asks for revisions at no extra cost as long as they don't involve changes in the script.

This company has received an equity loan from the Support Program for Technology Entrepreneurs of the Canary Islands JEREMIE Fund and has been 85% co-funded by the European Regional Development Fund from the Canary Islands 2007-2013 ERDF Operational Programme, contributing to the achievement of the objectives of the Axis 2 "Business Development and innovation", the priority theme 9 "Other actions to stimulate research, innovation and entrepreneurship in SMEs.


Once you’ve identified a pool of candidates based on skills and availability, look at their experience and browse their gig gallery. Listen to samples of previous voice-over work to get a sense of their style, and choose the candidate whose style you like best. You can contact them before ordering, explain your project requirements, expectations, and budget, and provide examples of work you like by the seller or someone else as an audio reference.

No place is totally silent, so find the best place you can — even if that means thinking outside the box. I have a friend who regularly records his podcast in his car. He lives in a small house with dogs and kids, so there really isn’t anywhere else quiet enough. He takes his laptop and mic out to his driveway, shuts himself in the car and records. The results are surprisingly good!

Both union and non-union have advantages and disadvantages; ultimately, it’s a decision that you, as a voice over actor, will have to make. Like everything else, it’s of critical importance that you do your research and weigh up the pros and cons. Seasoned pros will usually tell you it’s best to be a union member because, if you run into trouble, the union will fight your cause.

In late 2009, my wife Simone received an email from Prague in the Czech Republic. The sender, Mirek Jirku, was heading up a project to record voice messages for the foreign‑language versions of the latest Avast! anti‑virus software. Mirek sent us eight messages to be recorded, specified the fee and deadline, and requested a slow, friendly read. He asked us to send separate stereo MP3 files (at 160kbps or higher quality) for each message, specified that we'd have to sign a non‑disclosure agreement before recording, that we'd need to invoice afterwards, and that he'd pay via a wire transfer instead of PayPal (which is often used for international payments).


Voice over is a production technique where a voice that is not part of the narrative is heard over the action. It’s often used in movies, TV shows, plays, or other presentations. Voice over is an effective way to convey information that doesn’t naturally fit into the plot or the other visual elements that are occurring. Voice over work is read by a voice actor who reads from a script, and it is added to the other elements during production.
It's only after this sort of processing that I'll start cleaning up the recording and dealing with the gaps of silence between spoken passages. A noise gate (or an off‑line 'strip‑silence' function) can be used to automatically mute sections that fall below a certain level. However, if not used carefully, these tools will clip the 'T's and 'P's off the ends of words, and shut out natural breathing sounds. Worse, if your recording is noisy, a noise gate will actually draw attention to the problem, since your client will be able to hear the difference between room tone and absolute muting. Another trick is to use a downward expander to reduce the noise floor of quiet sections, rather than cut out the noise completely.
The engineering role will probably be the most familiar to regular SOS readers, and the issues of technical quality for digital audio in voiceover work are no different than they are for any other recording session. The key difference is that some clients will expect you to deliver 48kHz files instead of the 44.1kHz ones that are usually used in the music business. The 48kHz sample rate ensures that there's an integer number of audio samples for each frame of a standard 24 or 25 frames‑per‑second video recording.
When you come to actually recording your voice, try to think of the mic as the ear of your listener. Picture your listener, have an opinion, and read the script as if the words were coming to mind that instant. The distance between your mouth and the mic should be about the same as the distance between your thumb and pinkie when making a hang‑five gesture (see the picture above). Move closer to the mic when you lower your voice and back off when you speak louder. On‑line dictionaries such as the Merriam‑Webster one pictured here, often include audio examples which can help you clarify pronunciation. Just make sure that you use an American English or UK English (or other language!) version as appropriate. (Remember, while you have your engineer hat on, to take account of this when setting levels.) Always use a pop shield, and I'd suggest trying to work slightly off‑axis, as talking to a point just to the right or left of the mic will prevent bursts of air and drops of saliva ruining your recording. I'd also recommend wearing headphones over one ear only, as this allows you to judge volume and listen for clipping and plosives on the recording, while also hearing your natural voice, which makes it easier to focus on that message we talked about. Simone demonstrates this technique in the picture on the next page. Hhe's working slightly off‑axis and has backed off an inch or two to deliver with more energy.Typically, you'd record with your mouth approximately the distance between your thumb and little finger from the mic, as pictured here.
Next, run these files through any standard EQ high‑pass and low‑pass filters you use, zoom in on the waveform, and select a one‑second strip of silence from each recording. Save these strips as separate files. For instance, on my system, a one‑second strip of silence recorded at 16‑bit, 44.1kHz on a Neumann TLM103 would have this name: room_tone_neumann_tlm_103_44100_16_one_second.wav. Ideally, the noise floor of each strip will be lower than ‑60dB. Now, when you have to remove a bump or a squeak between words, you can paste in a piece of these strips instead of muting, which would draw attention to the edit.

"The editing process for all our titles starts with receiving the Pro Tools sessions or WAV files and the engineer's script, which has the markings of how many takes there were, and which ones the director liked best. In some cases, I use Strip Silence and add a bed of room tone to expedite the assembly edit. In others I'll add the room tone as I move through the audio. Once I had all the final takes to be used in [Favorite African Folk Tales], I went back to do a fine‑edit pass and created notes on any issues, such as misreads, mispronunciations, noises, and so on. With that list, I was able to discuss with Alfre how we would address the issues. Since the actors' schedules did not permit them to come back in to do pick‑ups I had to do some creative editing.” 

It's only after this sort of processing that I'll start cleaning up the recording and dealing with the gaps of silence between spoken passages. A noise gate (or an off‑line 'strip‑silence' function) can be used to automatically mute sections that fall below a certain level. However, if not used carefully, these tools will clip the 'T's and 'P's off the ends of words, and shut out natural breathing sounds. Worse, if your recording is noisy, a noise gate will actually draw attention to the problem, since your client will be able to hear the difference between room tone and absolute muting. Another trick is to use a downward expander to reduce the noise floor of quiet sections, rather than cut out the noise completely.
No place is totally silent, so find the best place you can — even if that means thinking outside the box. I have a friend who regularly records his podcast in his car. He lives in a small house with dogs and kids, so there really isn’t anywhere else quiet enough. He takes his laptop and mic out to his driveway, shuts himself in the car and records. The results are surprisingly good!
"This was Alfre Woodard's audiobook directing debut, and she pulled an amazing performance from people. The big [thing] was to remember that these stories were being told in intimate settings, one‑on‑one in most cases, so the talent really needed to speak to the individual listener. An image kept in mind was stories being told around a campfire, back when folktales were passed down by spoken word.”
The advice we present here is tried, tested, and true. Peter Dickson is the foremost leading professional voice actor in the UK known for voicing the X-Factor, Britain’s Got Talent, Live at the Apollo, The London 2012 Olympic Games and countless brand commercials. In a stellar  career spanning 40 years, he has worked on over 120 TV shows and series, many of them award winning, been a promo voice on 60 TV and Radio channels around the world, been a featured voice actor on 30 AAA game titles, and voiced in excess of 30,000 radio and TV commercials!
Voiceover-Services.com welcomes you to listen & consider professional voice actor Paul Fraley for your next campaign or project. Located in Los Angeles, Paul brings an excitement & unique point-of-view to his work. Whether voicing National TV commercials, explainer videos, creating character voices for international video game apps or as the signature voice for a mid-west grocery store chain – Paul always looks forward to telling the next story.
"We recorded two or three takes of each story, and within those takes there were some pick‑ups [overdubs] for certain lines. When I was editing, I used takes that gave the best delivery, had the least movement or other noise, and provided the most provoking images. In some cases [we used] the first take. Sometimes, after saying a line over and over, one starts to lose the meaning of the line. Pick‑ups should go back to the top of the sentence, making editing much easier.”
A demo recording of you doing voice-over work is your CV and your business card combined. If you're applying for a voice-over job, you can send the potential customer your demo via the Internet. Ideally you have multiple demos for different types of gigs. For commercials, clients want to hear 60 to 90 seconds of voice work. If you're auditioning as an audiobook reader, five minutes of demo proves that you can stay in character over a longer stretch of time.
Some might think that the audio portion of a video takes a backseat to the visual portions, but that’s not true. Most video watchers note that they are more likely to stop watching a video with bad audio vs. lower-quality video. In fact, a recent TechSmith study of video viewing habits showed that more than 25% of video viewers watched a video all the way through because the audio was good — more than those who said professional video style was most important.
You start off each job as a producer, consulting your client and getting briefed on the project at hand. Then you become an engineer, dealing with recording gear and software, setting the mic position and levels. Next, you step up to the mic as an actor, bringing the script off the page and connecting with the listener. Meanwhile, the director in you sits behind the metaphorical glass, making sure the actor doesn't mispronounce a word or stumble through a passage of text. Then you're an editor, cleaning up the best take and sending the resulting audio to your client. You need to be able to perform all of these roles to a high standard, and the better you are at each, the more your business will prosper.
Like pacing, vocal tone and inflection refer to ensuring you speak in a natural and pleasant manner. You want to be friendly and engaging, but not so much that you sound fake. No one wants to sound like a game show host. But, you also want to avoid monotone robot voice which, like pacing that’s too slow, can be boring and off-putting for listeners.
I’m new to this so keep that in mind, but I use a cheap “dog training clicker” to mark my redo portions. They are very visible in the sound track. In longer recording sessions (where I won’t remember the error) I’m experimenting with using 1,2 or 3 clicks to indicate how far I plan to back up for the restart. I can often find and do the cut without have to play anything – that by having an idea of how far back I need to look.

Voiceover-Services.com welcomes you to listen & consider professional voice actor Paul Fraley for your next campaign or project. Located in Los Angeles, Paul brings an excitement & unique point-of-view to his work. Whether voicing National TV commercials, explainer videos, creating character voices for international video game apps or as the signature voice for a mid-west grocery store chain – Paul always looks forward to telling the next story.

×