Some of you might be wondering about the difference between voice over and narration. The short answer: not much. In most cases, you may use voice over and narration fairly interchangeably. However, to be technically correct, narration typically refers to an audio vocal that describes all the action on screen or tells a story based on what’s happening, while voice over may or may not describe as much action and is often more instructional in nature.

"When recording voiceovers at home, you have to focus on performance: keep your energy levels up, stay true to the page, pronounce words correctly and consistently, and make sure you keep to a schedule to make the deadline. Prep well so you don't waste time second‑guessing yourself, looking up words as you go, and remember to not over‑ or under‑direct yourself. Also, make sure you know your recording equipment and room well; being able to quickly make adjustments to mic placement, levels, and so on, will make you more efficient.”


3. You need a simple, reliable, home-recording setup. Keep in mind: Your objective is on being the best voice talent you can be, not the best production studio or recording engineer. Nevertheless, you do need the ability to record, edit, and turnaround a proper audition. Do not run out and purchase a mic! You can’t return it, for hygienic reasons. Besides, there’s a bit of a learning curve to this and recent industry advances have made having a home “studio” easier and more affordable than ever before. You could have the best gear and the coolest toys on the block, but if you can’t use them it’s a waste. (Tip: What you’re recording on matters less than where you’re recording. Find a quiet place like a closet full of clothes to record in.)

"Ideally the talent should be seated, staying on axis, approximately a foot away from the mic, which should be angled back from the face a bit, not parallel to it. You'll need to see what angle provides the best results, usually a few degrees off from parallel works great — and located between the forehead and the nose, not directly in line with the mouth. This will help with plosives, mouth noise, and some other issues. Movement in the booth should be limited, as the microphone is likely to pick up arms flailing, hands rubbing, page turns, stomach growling, and so on. Keep the levels consistent, moving closer if the scene calls for a whisper, or moving back for a loud voice or scream. A well‑versed narrator is capable of delivering a dynamic performance without creating dynamic levels.”
It's a good idea to record with one ear free from your headphones, as this helps you to deliver a more natural performance.When recording solo, I find the role of director the hardest to play. How can you lose yourself in the moment if you're on the lookout for mistakes? If you stop each time you mispronounce a word or use the wrong intonation, your spoken‑word recording will sound choppy and unnatural. It's for this reason that I like to record each job twice. The first time, I push the director out of the room and focus on the message. If possible, I even let the soundtrack of the video I'm narrating play quietly in my headphones, and I don't stop for mistakes any more than I would if I were telling a story to a friend. During the second take, I let the director back into the room, to make sure I pronounce everything correctly and emphasise the correct information — though I still try to keep the performance honest and natural. 

There are lots of ways to get voice acting work, from online sites such as Bodalgo.com, Mandy.com, Voice123 and Voices.com. These are known as pay to play sites. They have lots of opportunities for you to audition, but it is highly competitive. Looking locally for businesses, including radio stations, that need voiceover is also a good way to start.
Congratulations! You should now have a finished voiceover recording. Save a final copy with the extension _master and use this version to save another copy in the format requested by the client. But don't think your job is done when you hand everything back to your producer‑self. Running a profitable home‑based voiceover business takes more than building and equipping a home studio and recording and editing audio files. You still have to design a web site, launch a marketing campaign, and secure new clients — all of which is something we'll look at another time.  
Once you’ve identified a pool of candidates based on skills and availability, look at their experience and browse their gig gallery. Listen to samples of previous voice-over work to get a sense of their style, and choose the candidate whose style you like best. You can contact them before ordering, explain your project requirements, expectations, and budget, and provide examples of work you like by the seller or someone else as an audio reference.
If a client likes your demo, they may invite you to audition. In the 21st century, you can download the audition script, record the audition at home, and then send the results to your client over the Internet. Prepare yourself for a life of constant auditions: Even successful voice pros may do many more auditions than actual jobs. But if enough jobs come your way, it's worth it.
Get your computer out of the room. Your microphone will pick up fan noise from your computer. Unless you have a solid state drive that is completely silent, you will want to set up a monitor in your studio and run cables through your wall to a computer outside the room. You can use a wireless keyboard and mouse to control your recording software. This also cuts down on the heat of your studio.
Both union and non-union have advantages and disadvantages; ultimately, it’s a decision that you, as a voice over actor, will have to make. Like everything else, it’s of critical importance that you do your research and weigh up the pros and cons. Seasoned pros will usually tell you it’s best to be a union member because, if you run into trouble, the union will fight your cause.
One of my favorite things about being a voice-over actor is the incredibly supportive community. Use your community to communicate with other voice-over actors regarding rates and best business practices. I have rarely found anyone who is secretive or not willing to share their past experiences. By being a generous and communicative community, we are stronger as voice actors and can advocate for ourselves to get paid appropriately. If you are operating from a home studio and all communication is between yourself and the client (versus an agent as the intermediary) it’s usually your responsibility to invoice after sending your VO files. I always include a polite 30-day payment term at the bottom of my invoice. In certain states (for example, New York) there is a “Freelancing isn’t Free Act”, in which you can politely mention to be paid in a timely manner.
You start off each job as a producer, consulting your client and getting briefed on the project at hand. Then you become an engineer, dealing with recording gear and software, setting the mic position and levels. Next, you step up to the mic as an actor, bringing the script off the page and connecting with the listener. Meanwhile, the director in you sits behind the metaphorical glass, making sure the actor doesn't mispronounce a word or stumble through a passage of text. Then you're an editor, cleaning up the best take and sending the resulting audio to your client. You need to be able to perform all of these roles to a high standard, and the better you are at each, the more your business will prosper.

I use the Adobe Audition package to edit my own voiceover work, but the techniques described below can be used in most audio‑editing software. Start by saving a new version of your original recording. (I keep the name of the file the same, but change the extension from _original to _edit.) Next, I'll turn my attention to the end of the recording, where I stepped away from the mic after the second take and recorded about 10 seconds of silence. Although processing is usually kept to a minimum, dealing with sibilance is important, and Eiosis' De‑esser plug‑in is much more precise than most.Wearing headphones, I can zoom in on this 'silence', turn up the volume, and listen for any background noise. If I notice any constant noise seeping into the recording, I may consider using Adobe Audition's noise‑reduction tool to capture a one‑ or two‑second profile of the silence, and then reduce the offending noise by about 75 percent throughout the recording. I should stress that this is rarely needed, and it's always a last resort, because such processing can generate swirly, metallic artifacts that draw more attention to themselves than the noise you intended to eliminate! But it's good to listen for such issues with fresh ears at the start of your editing session. If you find yourself using noise‑reduction often, that's a sign that you should find a better place to record, or improve the isolation of the space you've chosen. Don't forget that there are other ways to deal with some noise: often, a high‑pass filter is all you will need to clean up a recording, for example. Also remember that if your recording is to be mixed with music, slight background noise won't be noticeable, and that the more exposed your voice in the end product, the more problematic noise will become.
It's only after this sort of processing that I'll start cleaning up the recording and dealing with the gaps of silence between spoken passages. A noise gate (or an off‑line 'strip‑silence' function) can be used to automatically mute sections that fall below a certain level. However, if not used carefully, these tools will clip the 'T's and 'P's off the ends of words, and shut out natural breathing sounds. Worse, if your recording is noisy, a noise gate will actually draw attention to the problem, since your client will be able to hear the difference between room tone and absolute muting. Another trick is to use a downward expander to reduce the noise floor of quiet sections, rather than cut out the noise completely.
It's only after this sort of processing that I'll start cleaning up the recording and dealing with the gaps of silence between spoken passages. A noise gate (or an off‑line 'strip‑silence' function) can be used to automatically mute sections that fall below a certain level. However, if not used carefully, these tools will clip the 'T's and 'P's off the ends of words, and shut out natural breathing sounds. Worse, if your recording is noisy, a noise gate will actually draw attention to the problem, since your client will be able to hear the difference between room tone and absolute muting. Another trick is to use a downward expander to reduce the noise floor of quiet sections, rather than cut out the noise completely.
Be mindful of the sounds of your heating and cooling system (this goes for a home recording studio, as well). If you can’t find a spot where you can’t hear air rushing through your ducts, you may want to shut down your furnace or AC for the duration of your recording. If your recording space is near a window, listen for sounds of traffic — especially loud trucks. They will definitely show up in your recording.
If a client likes your demo, they may invite you to audition. In the 21st century, you can download the audition script, record the audition at home, and then send the results to your client over the Internet. Prepare yourself for a life of constant auditions: Even successful voice pros may do many more auditions than actual jobs. But if enough jobs come your way, it's worth it. 

Get your computer out of the room. Your microphone will pick up fan noise from your computer. Unless you have a solid state drive that is completely silent, you will want to set up a monitor in your studio and run cables through your wall to a computer outside the room. You can use a wireless keyboard and mouse to control your recording software. This also cuts down on the heat of your studio.
Also listen for sibilance. Strong 'ess' sounds are best corrected at source, by using good mic technique, but sometimes they're unavoidable. If you hear an 'ess' that really sizzles in your recording, you can manually reduce its volume. You can, of course, also use a de‑esser, but do be careful, as applying some de‑essers to the entire audio file can alter the sound of your recording. It often works best to apply them to short sections, either offline or using automation. My preferred de‑esser plug‑in is the one sold by Eiosis (www.eiosis.com),Make sure you record some silence at the end of each take. That way, if a great performance suffers from noise issues, you have something to feed your noise‑reduction processors. Just don't rely on this technique too much! which cleverly separates the esses from the rest of the audio and allows you to manipulate them independently. If you want to learn about some more advanced strategies for de‑essing check out Mike Senior's article from SOS May 2009 (/sos/may09/articles/deessing.htm).

It's only after this sort of processing that I'll start cleaning up the recording and dealing with the gaps of silence between spoken passages. A noise gate (or an off‑line 'strip‑silence' function) can be used to automatically mute sections that fall below a certain level. However, if not used carefully, these tools will clip the 'T's and 'P's off the ends of words, and shut out natural breathing sounds. Worse, if your recording is noisy, a noise gate will actually draw attention to the problem, since your client will be able to hear the difference between room tone and absolute muting. Another trick is to use a downward expander to reduce the noise floor of quiet sections, rather than cut out the noise completely.

A demo recording of you doing voice-over work is your CV and your business card combined. If you're applying for a voice-over job, you can send the potential customer your demo via the Internet. Ideally you have multiple demos for different types of gigs. For commercials, clients want to hear 60 to 90 seconds of voice work. If you're auditioning as an audiobook reader, five minutes of demo proves that you can stay in character over a longer stretch of time.
If a client likes your demo, they may invite you to audition. In the 21st century, you can download the audition script, record the audition at home, and then send the results to your client over the Internet. Prepare yourself for a life of constant auditions: Even successful voice pros may do many more auditions than actual jobs. But if enough jobs come your way, it's worth it.
You need to appreciate that there is a lot to learn and do before your first paid voice acting job. Yes, you want to get out there and start auditioning. But first, you’re going to need proper training, equipment, resources, and yes, some natural talent. The great news is that even though the voice over industry is competitive, there is plenty of voice over work out there for everyone. This guide on how to become a voice actor will give you a good idea of where to start.
No place is totally silent, so find the best place you can — even if that means thinking outside the box. I have a friend who regularly records his podcast in his car. He lives in a small house with dogs and kids, so there really isn’t anywhere else quiet enough. He takes his laptop and mic out to his driveway, shuts himself in the car and records. The results are surprisingly good!
ADR / Automated Dialogue Replacement in Salt Lake City, Utah Audio Mixing / Sound Recording Equipment Rentals in Salt Lake City, Utah Audio Mixing / Sweetening / Sound Editing / Sound Designers in Salt Lake City, Utah Audio Technicians / Audio Engineer / A1 / A2 in Salt Lake City, Utah Film Post Production Services in Salt Lake City, Utah Foley Stages in Salt Lake City, Utah Post House / Video Post Production Facilities / Editing Services in Salt Lake City, Utah Recording Studios in Salt Lake City, Utah Sound Mixers / Recordists in Salt Lake City, Utah Voice Over Artists in Salt Lake City, Utah
×