One of my favorite things about being a voice-over actor is the incredibly supportive community. Use your community to communicate with other voice-over actors regarding rates and best business practices. I have rarely found anyone who is secretive or not willing to share their past experiences. By being a generous and communicative community, we are stronger as voice actors and can advocate for ourselves to get paid appropriately. If you are operating from a home studio and all communication is between yourself and the client (versus an agent as the intermediary) it’s usually your responsibility to invoice after sending your VO files. I always include a polite 30-day payment term at the bottom of my invoice. In certain states (for example, New York) there is a “Freelancing isn’t Free Act”, in which you can politely mention to be paid in a timely manner. 

"Ideally the talent should be seated, staying on axis, approximately a foot away from the mic, which should be angled back from the face a bit, not parallel to it. You'll need to see what angle provides the best results, usually a few degrees off from parallel works great — and located between the forehead and the nose, not directly in line with the mouth. This will help with plosives, mouth noise, and some other issues. Movement in the booth should be limited, as the microphone is likely to pick up arms flailing, hands rubbing, page turns, stomach growling, and so on. Keep the levels consistent, moving closer if the scene calls for a whisper, or moving back for a loud voice or scream. A well‑versed narrator is capable of delivering a dynamic performance without creating dynamic levels.”
As the engineer, your key job is to select and set up the recording space, choose and position the microphone, set levels and make sure you're recording a good, clean signal at a healthy level. Like music, the louder the signal you want to record, the less audible the noise floor, but you don't want to have to speak louder than sounds natural, and you don't want to overcook things when tracking: any distortion will be very noticeable on an exposed voice part, and an otherwise great take with digital clipping won't be acceptable. If you notice clipping only when you start editing, software clip restoration tools might help to make the take usable, but it's not going to be perfect. Remember that although you may have needed to record 'hot' on analogue tape and older 16‑bit digital recording systems, modern 24‑bit A‑D converters can accommodate a much wider dynamic range, so you no longer have to track so loud: you can leave much more headroom.
"Ideally the talent should be seated, staying on axis, approximately a foot away from the mic, which should be angled back from the face a bit, not parallel to it. You'll need to see what angle provides the best results, usually a few degrees off from parallel works great — and located between the forehead and the nose, not directly in line with the mouth. This will help with plosives, mouth noise, and some other issues. Movement in the booth should be limited, as the microphone is likely to pick up arms flailing, hands rubbing, page turns, stomach growling, and so on. Keep the levels consistent, moving closer if the scene calls for a whisper, or moving back for a loud voice or scream. A well‑versed narrator is capable of delivering a dynamic performance without creating dynamic levels.”
A great performance recorded on mediocre gear will always sound better than a mediocre performance recorded on great gear. By preparing well, before the session, you'll find it far easier to relax and focus on the message and the listener. As a producer, it's important to be clear what the expected format is for the final audio file. Although there are certain 'standards', your clients' expectations will vary.Read through the script, look up any questionable words and check their pronunciation. For American English, which accounts for the majority of my work, my favourite pronunciation resource is the Merriam‑Webster on‑line dictionary (www.m‑w.com), which includes audio examples. If you don't know how to pronounce the name of a company or product, call the company's customer service centre (if anyone can pronounce it right, they can!). If you don't know how to pronounce the name of a person or city, try searching YouTube for news reports on the subject.
No place is totally silent, so find the best place you can — even if that means thinking outside the box. I have a friend who regularly records his podcast in his car. He lives in a small house with dogs and kids, so there really isn’t anywhere else quiet enough. He takes his laptop and mic out to his driveway, shuts himself in the car and records. The results are surprisingly good!
One of the most important rules is to ensure you value yourself as a professional. If you undervalue your own service it can be hard to later charge for the correct rates. A professional voice-over should cost a minimum amount, even if you’re new. If you allow clients to low-ball your work from the outset it will continue to set the expectation that they can get a voiceover from you on the cheap. This can then mean the difference between making a living and paying bills or not.
Before you get down to the nitty-gritty, though, I recommend doing a test recording to ensure your equipment works properly and your audio levels are strong. You don’t need to record the entire script, but a few paragraphs will give you enough to ensure that the audio is clear, at an appropriate level, and doesn’t include any stray or ambient noises. 

The contents of this article are subject to worldwide copyright protection and reproduction in whole or part, whether mechanical or electronic, is expressly forbidden without the prior written consent of the Publishers. Great care has been taken to ensure accuracy in the preparation of this article but neither Sound On Sound Limited nor the publishers can be held responsible for its contents. The views expressed are those of the contributors and not necessarily those of the publishers.
A demo recording of you doing voice-over work is your CV and your business card combined. If you're applying for a voice-over job, you can send the potential customer your demo via the Internet. Ideally you have multiple demos for different types of gigs. For commercials, clients want to hear 60 to 90 seconds of voice work. If you're auditioning as an audiobook reader, five minutes of demo proves that you can stay in character over a longer stretch of time.
It's only after this sort of processing that I'll start cleaning up the recording and dealing with the gaps of silence between spoken passages. A noise gate (or an off‑line 'strip‑silence' function) can be used to automatically mute sections that fall below a certain level. However, if not used carefully, these tools will clip the 'T's and 'P's off the ends of words, and shut out natural breathing sounds. Worse, if your recording is noisy, a noise gate will actually draw attention to the problem, since your client will be able to hear the difference between room tone and absolute muting. Another trick is to use a downward expander to reduce the noise floor of quiet sections, rather than cut out the noise completely.
Before you get down to the nitty-gritty, though, I recommend doing a test recording to ensure your equipment works properly and your audio levels are strong. You don’t need to record the entire script, but a few paragraphs will give you enough to ensure that the audio is clear, at an appropriate level, and doesn’t include any stray or ambient noises.

Also listen for sibilance. Strong 'ess' sounds are best corrected at source, by using good mic technique, but sometimes they're unavoidable. If you hear an 'ess' that really sizzles in your recording, you can manually reduce its volume. You can, of course, also use a de‑esser, but do be careful, as applying some de‑essers to the entire audio file can alter the sound of your recording. It often works best to apply them to short sections, either offline or using automation. My preferred de‑esser plug‑in is the one sold by Eiosis (www.eiosis.com),Make sure you record some silence at the end of each take. That way, if a great performance suffers from noise issues, you have something to feed your noise‑reduction processors. Just don't rely on this technique too much! which cleverly separates the esses from the rest of the audio and allows you to manipulate them independently. If you want to learn about some more advanced strategies for de‑essing check out Mike Senior's article from SOS May 2009 (/sos/may09/articles/deessing.htm).
Some clients are not experienced in voice over. So another way you can help them is to advice then and help them really understand all that goes into a voice over recording to get it to the final polished result. Of course you need to take this into account when you charge for your time and again whether this is a one off project or has potential to be a long term client.
"The editing process for all our titles starts with receiving the Pro Tools sessions or WAV files and the engineer's script, which has the markings of how many takes there were, and which ones the director liked best. In some cases, I use Strip Silence and add a bed of room tone to expedite the assembly edit. In others I'll add the room tone as I move through the audio. Once I had all the final takes to be used in [Favorite African Folk Tales], I went back to do a fine‑edit pass and created notes on any issues, such as misreads, mispronunciations, noises, and so on. With that list, I was able to discuss with Alfre how we would address the issues. Since the actors' schedules did not permit them to come back in to do pick‑ups I had to do some creative editing.”
In other words, Mirek gave us all the information we needed to start the job. Unfortunately, though, that's not how it usually works! Usually, you'll need to work hard to get all the information you need from your client to do the job well. If you're at all uncertain about their expectations, whether about the performance, or about technical and organisational issues such as file formats or payment procedures, save yourself time and a headache by clearing up all doubts beforehand, and don't hit the record button until your client has given you the green light by email. With that sorted, you can more easily don your other hats and get on with the job.
Our recommendation is to start small and reinvest the money you make into upgrading your equipment and set up. All clients, whether they are Pixar or just a guy who needs a voicemail message, expect crystal clear audio recordings. You absolutely MUST be recording in a professional recording environment with professional equipment. They are NOT going to settle for less than perfection. Does this mean spending thousands of dollars? Maybe, eventually it does, but not today. What you’ll need to get started:
Even if you're mixing yourself, it's better to add EQ and compression only when you can hear how it will sit with the soundtrack or special effects. Ultimately, it comes down to knowing what your voice will be used for and making a judgement. For instance, if I'm recording a tagline for a TV or radio advert, I'll generally run a mic into a nice preamp (where I might add slight tube warmth, and subtle EQ or compression, just to give the recording a bit of 'body'), and I may do a little de‑essing using a plug‑in when performing any edits. However, for e‑learning jobs, corporate videos and so on, I'll tend not to add any creative processing while recording or editing, and will only use the de‑esser ever so slightly.
In late 2009, my wife Simone received an email from Prague in the Czech Republic. The sender, Mirek Jirku, was heading up a project to record voice messages for the foreign‑language versions of the latest Avast! anti‑virus software. Mirek sent us eight messages to be recorded, specified the fee and deadline, and requested a slow, friendly read. He asked us to send separate stereo MP3 files (at 160kbps or higher quality) for each message, specified that we'd have to sign a non‑disclosure agreement before recording, that we'd need to invoice afterwards, and that he'd pay via a wire transfer instead of PayPal (which is often used for international payments).

"When recording voiceovers at home, you have to focus on performance: keep your energy levels up, stay true to the page, pronounce words correctly and consistently, and make sure you keep to a schedule to make the deadline. Prep well so you don't waste time second‑guessing yourself, looking up words as you go, and remember to not over‑ or under‑direct yourself. Also, make sure you know your recording equipment and room well; being able to quickly make adjustments to mic placement, levels, and so on, will make you more efficient.” 
×