"When recording voiceovers at home, you have to focus on performance: keep your energy levels up, stay true to the page, pronounce words correctly and consistently, and make sure you keep to a schedule to make the deadline. Prep well so you don't waste time second‑guessing yourself, looking up words as you go, and remember to not over‑ or under‑direct yourself. Also, make sure you know your recording equipment and room well; being able to quickly make adjustments to mic placement, levels, and so on, will make you more efficient.”
It’s equally important to realize that when you join a union, you pledge to no longer accept non-union work. The reason for this is solidarity: you stand together with your fellow members so that you can negotiate better working conditions and pay for all of you as a collective. It’s worth noting, however, that a union in any given country only functions within the borders of that country and not beyond them.

Both union and non-union have advantages and disadvantages; ultimately, it’s a decision that you, as a voice over actor, will have to make. Like everything else, it’s of critical importance that you do your research and weigh up the pros and cons. Seasoned pros will usually tell you it’s best to be a union member because, if you run into trouble, the union will fight your cause.
At this point — unless you're tracking for broadcast applications (where they don't work to peak levels) — consider 'normalising' your recording to an optimal level. Normalisation can be used to push the loudest peak to around ‑1dB and increase the volume of the entire recording by the same ratio. Of course, you can also tighten up dynamic range (the difference between the softest and loudest parts of your recording) by manually reducing the loudest sections of the recording before you apply normalisation. On a final note, if you do plan to use a compressor, then you might as well add gain at that stage instead of normalising.
Not all noise can be tackled in this way, though: you need to listen for clicks, plosives, digital glitches and the like. These can normally be acceptably repaired by using a 'heal' tool, or a pencil tool to redraw the waveform. Popped 'p's can often be 'fixed' using a high‑pass filter set at 100Hz. For a single glitch, you can zoom in and cut out the cycle of the waveform in which the glitch appears. Just be careful to start and end the cut where the waveform crosses the centre line, otherwise you'll inadvertently add another digital glitch. If glitches are frequent, it's likely that there's a problem with your audio interface's buffer settings — it may be just a playback issue. 

As the engineer, your key job is to select and set up the recording space, choose and position the microphone, set levels and make sure you're recording a good, clean signal at a healthy level. Like music, the louder the signal you want to record, the less audible the noise floor, but you don't want to have to speak louder than sounds natural, and you don't want to overcook things when tracking: any distortion will be very noticeable on an exposed voice part, and an otherwise great take with digital clipping won't be acceptable. If you notice clipping only when you start editing, software clip restoration tools might help to make the take usable, but it's not going to be perfect. Remember that although you may have needed to record 'hot' on analogue tape and older 16‑bit digital recording systems, modern 24‑bit A‑D converters can accommodate a much wider dynamic range, so you no longer have to track so loud: you can leave much more headroom.
It’s equally important to realize that when you join a union, you pledge to no longer accept non-union work. The reason for this is solidarity: you stand together with your fellow members so that you can negotiate better working conditions and pay for all of you as a collective. It’s worth noting, however, that a union in any given country only functions within the borders of that country and not beyond them.
The advice we present here is tried, tested, and true. Peter Dickson is the foremost leading professional voice actor in the UK known for voicing the X-Factor, Britain’s Got Talent, Live at the Apollo, The London 2012 Olympic Games and countless brand commercials. In a stellar  career spanning 40 years, he has worked on over 120 TV shows and series, many of them award winning, been a promo voice on 60 TV and Radio channels around the world, been a featured voice actor on 30 AAA game titles, and voiced in excess of 30,000 radio and TV commercials!
The contents of this article are subject to worldwide copyright protection and reproduction in whole or part, whether mechanical or electronic, is expressly forbidden without the prior written consent of the Publishers. Great care has been taken to ensure accuracy in the preparation of this article but neither Sound On Sound Limited nor the publishers can be held responsible for its contents. The views expressed are those of the contributors and not necessarily those of the publishers.
"Ideally the talent should be seated, staying on axis, approximately a foot away from the mic, which should be angled back from the face a bit, not parallel to it. You'll need to see what angle provides the best results, usually a few degrees off from parallel works great — and located between the forehead and the nose, not directly in line with the mouth. This will help with plosives, mouth noise, and some other issues. Movement in the booth should be limited, as the microphone is likely to pick up arms flailing, hands rubbing, page turns, stomach growling, and so on. Keep the levels consistent, moving closer if the scene calls for a whisper, or moving back for a loud voice or scream. A well‑versed narrator is capable of delivering a dynamic performance without creating dynamic levels.”
In other words, Mirek gave us all the information we needed to start the job. Unfortunately, though, that's not how it usually works! Usually, you'll need to work hard to get all the information you need from your client to do the job well. If you're at all uncertain about their expectations, whether about the performance, or about technical and organisational issues such as file formats or payment procedures, save yourself time and a headache by clearing up all doubts beforehand, and don't hit the record button until your client has given you the green light by email. With that sorted, you can more easily don your other hats and get on with the job.
"The editing process for all our titles starts with receiving the Pro Tools sessions or WAV files and the engineer's script, which has the markings of how many takes there were, and which ones the director liked best. In some cases, I use Strip Silence and add a bed of room tone to expedite the assembly edit. In others I'll add the room tone as I move through the audio. Once I had all the final takes to be used in [Favorite African Folk Tales], I went back to do a fine‑edit pass and created notes on any issues, such as misreads, mispronunciations, noises, and so on. With that list, I was able to discuss with Alfre how we would address the issues. Since the actors' schedules did not permit them to come back in to do pick‑ups I had to do some creative editing.”
If a client likes your demo, they may invite you to audition. In the 21st century, you can download the audition script, record the audition at home, and then send the results to your client over the Internet. Prepare yourself for a life of constant auditions: Even successful voice pros may do many more auditions than actual jobs. But if enough jobs come your way, it's worth it.
Boom Operators in Salt Lake City, Utah Foreign Language Dubbing in Salt Lake City, Utah Music Composers in Salt Lake City, Utah Music Coordinators / Supervisors in Salt Lake City, Utah Music Licensing in Salt Lake City, Utah Music Producers in Salt Lake City, Utah Music Scoring / Film Score in Salt Lake City, Utah Soundtrack Production / Jingles Production in Salt Lake City, Utah
You will never have to answer to a “boss”, but you will need to be your own boss and manage yourself. You will work on your own a lot of the time. So you need to embrace the benefits and the challenges this presents. Take courses in areas where you need to develop your skills. When you adequately prepare for running a business, you will succeed in its management, even if part of managing your business means hiring out, in areas that you know are not your strongest.
This company has received an equity loan from the Support Program for Technology Entrepreneurs of the Canary Islands JEREMIE Fund and has been 85% co-funded by the European Regional Development Fund from the Canary Islands 2007-2013 ERDF Operational Programme, contributing to the achievement of the objectives of the Axis 2 "Business Development and innovation", the priority theme 9 "Other actions to stimulate research, innovation and entrepreneurship in SMEs.
As editor, you need to turn the raw recording into the final version of the file you'll be sending to your client. Editing during a recording session can be problematic, and particularly so if you're recording in a domestic environment. How can you expect to hear the drone of the dishwasher ruining your recording if the dishwasher is still running as you edit? I'll look in more detail at setting up a voiceover recording studio next time, but for now, if recording in a separate room or isolated booth isn't an option, at least try to edit the file the following morning (or maybe at night) when there's less noise around — because hearing your recording with a fresh ear and in a quieter environment will help you to make better editing decisions, and will reveal noises that slipped your attention earlier.
Some of you might be wondering about the difference between voice over and narration. The short answer: not much. In most cases, you may use voice over and narration fairly interchangeably. However, to be technically correct, narration typically refers to an audio vocal that describes all the action on screen or tells a story based on what’s happening, while voice over may or may not describe as much action and is often more instructional in nature.

Voiceover-Services.com welcomes you to listen & consider professional voice actor Paul Fraley for your next campaign or project. Located in Los Angeles, Paul brings an excitement & unique point-of-view to his work. Whether voicing National TV commercials, explainer videos, creating character voices for international video game apps or as the signature voice for a mid-west grocery store chain – Paul always looks forward to telling the next story.
Much of the working week as a voice actor, is taken up with auditioning. The success of auditions will depend on your skill, understanding of the brief, speed to deliver, your technical ability and how well you record your voice. By tracking and improving your success your can improve the ratio of auditions to paid work. This in itself requires you to match your voice to the auditions that are a natural fit to your vocal ability and style. As your experience and voice skills expand, so the breadth of work that you can audition for increases.
Some of you might be wondering about the difference between voice over and narration. The short answer: not much. In most cases, you may use voice over and narration fairly interchangeably. However, to be technically correct, narration typically refers to an audio vocal that describes all the action on screen or tells a story based on what’s happening, while voice over may or may not describe as much action and is often more instructional in nature.

Before you get down to the nitty-gritty, though, I recommend doing a test recording to ensure your equipment works properly and your audio levels are strong. You don’t need to record the entire script, but a few paragraphs will give you enough to ensure that the audio is clear, at an appropriate level, and doesn’t include any stray or ambient noises.

×