2. You need training. “Winging it” isn’t professional because it’s unreliable, and could explain why there are so many one-hit wonders in this profession. You need a professional approach, mic technique training, and time dedicated to practice, practice, practice in order to build your skills. Your confidence will build from there. Much like circuit training fine tunes your physical acuity with continued use, technique training conditions your performance muscle. You can’t expect to run a marathon if you don’t train. Every skill level of talent benefits from proper coaching.
It’s equally important to realize that when you join a union, you pledge to no longer accept non-union work. The reason for this is solidarity: you stand together with your fellow members so that you can negotiate better working conditions and pay for all of you as a collective. It’s worth noting, however, that a union in any given country only functions within the borders of that country and not beyond them.
The contents of this article are subject to worldwide copyright protection and reproduction in whole or part, whether mechanical or electronic, is expressly forbidden without the prior written consent of the Publishers. Great care has been taken to ensure accuracy in the preparation of this article but neither Sound On Sound Limited nor the publishers can be held responsible for its contents. The views expressed are those of the contributors and not necessarily those of the publishers.
As I've mentioned, most of our clients prefer to do post‑production work themselves, and request the raw (but edited) recordings. Sometimes, though, as in the Avast! job, the client will want the files ready to go, which might mean using slight EQ and compression. The noise floor on my recordings generally hovers around ‑54dB, but by using EQ to roll off frequencies below 80Hz and above 12kHz, I am usually able to lower the noise floor to around ‑57dB without resorting to noise reduction. Using EQ to reduce low‑end rumble and high‑frequency noise will make your recording sound better, and will be particularly beneficial if you'll be adding compression later, as the compressor's make-up gain won't be raising the level of that noise. Used moderately, compression can usefully reduce dynamic range, and thus improve intelligibility of the words, while still leaving you with a natural‑sounding result. Used excessively, it will suck the life out of a recording.
Voice actors get paid on a per project or per job basis. Your earnings as a voice actor range from: $35 for a small market radio spot, $150 for a 15 second recording for say a small website, $250 – $350 for a 30 second major market radio commercial (Plus use fees) to about $2000 – $5000 per audiobook, as an established voice talent. There are several ways to calculate how much voice actors get paid, with the most common being the word count of the script. The use of the material is also taken into consideration and whether or not you are granting a license to use your material for a specific duration on specific channels or if you are seeking a fee for a universal buyout.
Some clients are not experienced in voice over. So another way you can help them is to advice then and help them really understand all that goes into a voice over recording to get it to the final polished result. Of course you need to take this into account when you charge for your time and again whether this is a one off project or has potential to be a long term client.
As the engineer, your key job is to select and set up the recording space, choose and position the microphone, set levels and make sure you're recording a good, clean signal at a healthy level. Like music, the louder the signal you want to record, the less audible the noise floor, but you don't want to have to speak louder than sounds natural, and you don't want to overcook things when tracking: any distortion will be very noticeable on an exposed voice part, and an otherwise great take with digital clipping won't be acceptable. If you notice clipping only when you start editing, software clip restoration tools might help to make the take usable, but it's not going to be perfect. Remember that although you may have needed to record 'hot' on analogue tape and older 16‑bit digital recording systems, modern 24‑bit A‑D converters can accommodate a much wider dynamic range, so you no longer have to track so loud: you can leave much more headroom.
3. You need a simple, reliable, home-recording setup. Keep in mind: Your objective is on being the best voice talent you can be, not the best production studio or recording engineer. Nevertheless, you do need the ability to record, edit, and turnaround a proper audition. Do not run out and purchase a mic! You can’t return it, for hygienic reasons. Besides, there’s a bit of a learning curve to this and recent industry advances have made having a home “studio” easier and more affordable than ever before. You could have the best gear and the coolest toys on the block, but if you can’t use them it’s a waste. (Tip: What you’re recording on matters less than where you’re recording. Find a quiet place like a closet full of clothes to record in.)
First of all, don’t be put off by the word technical. The ‘technical’ skills you need to learn to involve how you record and then edit your recording and of course you will need a home studio to do this. This needn’t be a daunting prospect though. Many freelance sound engineers are available who can help you with this – contact us if you want a reputable one.
Voiceover-Services.com welcomes you to listen & consider professional voice actor Paul Fraley for your next campaign or project. Located in Los Angeles, Paul brings an excitement & unique point-of-view to his work. Whether voicing National TV commercials, explainer videos, creating character voices for international video game apps or as the signature voice for a mid-west grocery store chain – Paul always looks forward to telling the next story.
×