Also listen for sibilance. Strong 'ess' sounds are best corrected at source, by using good mic technique, but sometimes they're unavoidable. If you hear an 'ess' that really sizzles in your recording, you can manually reduce its volume. You can, of course, also use a de‑esser, but do be careful, as applying some de‑essers to the entire audio file can alter the sound of your recording. It often works best to apply them to short sections, either offline or using automation. My preferred de‑esser plug‑in is the one sold by Eiosis (www.eiosis.com),Make sure you record some silence at the end of each take. That way, if a great performance suffers from noise issues, you have something to feed your noise‑reduction processors. Just don't rely on this technique too much! which cleverly separates the esses from the rest of the audio and allows you to manipulate them independently. If you want to learn about some more advanced strategies for de‑essing check out Mike Senior's article from SOS May 2009 (/sos/may09/articles/deessing.htm).
I use the Adobe Audition package to edit my own voiceover work, but the techniques described below can be used in most audio‑editing software. Start by saving a new version of your original recording. (I keep the name of the file the same, but change the extension from _original to _edit.) Next, I'll turn my attention to the end of the recording, where I stepped away from the mic after the second take and recorded about 10 seconds of silence. Although processing is usually kept to a minimum, dealing with sibilance is important, and Eiosis' De‑esser plug‑in is much more precise than most.Wearing headphones, I can zoom in on this 'silence', turn up the volume, and listen for any background noise. If I notice any constant noise seeping into the recording, I may consider using Adobe Audition's noise‑reduction tool to capture a one‑ or two‑second profile of the silence, and then reduce the offending noise by about 75 percent throughout the recording. I should stress that this is rarely needed, and it's always a last resort, because such processing can generate swirly, metallic artifacts that draw more attention to themselves than the noise you intended to eliminate! But it's good to listen for such issues with fresh ears at the start of your editing session. If you find yourself using noise‑reduction often, that's a sign that you should find a better place to record, or improve the isolation of the space you've chosen. Don't forget that there are other ways to deal with some noise: often, a high‑pass filter is all you will need to clean up a recording, for example. Also remember that if your recording is to be mixed with music, slight background noise won't be noticeable, and that the more exposed your voice in the end product, the more problematic noise will become. 

Recording voice overs like a pro isn’t that difficult when you know how to do it. You may have noticed that the actual recording part plays little part when compared to the preparation. Taking the proper steps before you hit the record button and then taking the time to edit your audio appropriately will go a long way to ensuring your voice overs sound professional and engaging.
There are now more opportunities in the voiceover industry than ever before — but competition has never been so fierce — so, in this short series of articles I'll set out what you need to know to get started as a home‑studio voiceover artist, and turn it into a paying job. This month, I'll explain some differences between the voiceover and music industries, and run through the different roles you'll need to become good at. Next time, I'll discuss what makes a good voice, the sort of home‑studio setup you need, and how you can start to get the jobs coming in.
Even if you're mixing yourself, it's better to add EQ and compression only when you can hear how it will sit with the soundtrack or special effects. Ultimately, it comes down to knowing what your voice will be used for and making a judgement. For instance, if I'm recording a tagline for a TV or radio advert, I'll generally run a mic into a nice preamp (where I might add slight tube warmth, and subtle EQ or compression, just to give the recording a bit of 'body'), and I may do a little de‑essing using a plug‑in when performing any edits. However, for e‑learning jobs, corporate videos and so on, I'll tend not to add any creative processing while recording or editing, and will only use the de‑esser ever so slightly.
The quality of your voice over depends almost entirely o the skill of the voice actor you use. A good voice actor will have perfect enunciation (ie, be very easy to understand), speak at an ideal pace (not too fast and not too slow), and have a pleasing voice. They should also be good at acting, and able to convey the feeling or emotions required by the script, using vocal variance and tone to keep the words interesting while also embodying the desired mood.

3. You need a simple, reliable, home-recording setup. Keep in mind: Your objective is on being the best voice talent you can be, not the best production studio or recording engineer. Nevertheless, you do need the ability to record, edit, and turnaround a proper audition. Do not run out and purchase a mic! You can’t return it, for hygienic reasons. Besides, there’s a bit of a learning curve to this and recent industry advances have made having a home “studio” easier and more affordable than ever before. You could have the best gear and the coolest toys on the block, but if you can’t use them it’s a waste. (Tip: What you’re recording on matters less than where you’re recording. Find a quiet place like a closet full of clothes to record in.)


As the engineer, your key job is to select and set up the recording space, choose and position the microphone, set levels and make sure you're recording a good, clean signal at a healthy level. Like music, the louder the signal you want to record, the less audible the noise floor, but you don't want to have to speak louder than sounds natural, and you don't want to overcook things when tracking: any distortion will be very noticeable on an exposed voice part, and an otherwise great take with digital clipping won't be acceptable. If you notice clipping only when you start editing, software clip restoration tools might help to make the take usable, but it's not going to be perfect. Remember that although you may have needed to record 'hot' on analogue tape and older 16‑bit digital recording systems, modern 24‑bit A‑D converters can accommodate a much wider dynamic range, so you no longer have to track so loud: you can leave much more headroom.

Because I've prepared properly, the first take is often the one I end up editing and sending to my client. The second is simply there as a safety net, in case I need to replace any mistakes while editing. It's much better to capture such drop‑ins during the same session as the main performance, as you can be sure that the mic will be in the same place and your voice will have a similar character in both takes.

Why the difference in approach? Lots of my e‑learning and corporate jobs are done for production houses that will be adding other voices to the mix. Ironically, if I record my voice via a great mic and preamp, and add some nice processing, it can end up standing out from the other voices, drawing attention to itself. The production house will see this as me causing them a problem, even though my recording sounds better than the others!


"Ideally the talent should be seated, staying on axis, approximately a foot away from the mic, which should be angled back from the face a bit, not parallel to it. You'll need to see what angle provides the best results, usually a few degrees off from parallel works great — and located between the forehead and the nose, not directly in line with the mouth. This will help with plosives, mouth noise, and some other issues. Movement in the booth should be limited, as the microphone is likely to pick up arms flailing, hands rubbing, page turns, stomach growling, and so on. Keep the levels consistent, moving closer if the scene calls for a whisper, or moving back for a loud voice or scream. A well‑versed narrator is capable of delivering a dynamic performance without creating dynamic levels.”
Why the difference in approach? Lots of my e‑learning and corporate jobs are done for production houses that will be adding other voices to the mix. Ironically, if I record my voice via a great mic and preamp, and add some nice processing, it can end up standing out from the other voices, drawing attention to itself. The production house will see this as me causing them a problem, even though my recording sounds better than the others!
Working with a top voiceover agency can bring you a steady stream of well paid work. The top voiceover agencies, like Hobsons in London or Abrams in NY and LA, have an elite set of voice actors as well as recognised visual actors who do voiceover. These top agencies are hard to get into though. They only take the very best established voice talent.
No place is totally silent, so find the best place you can — even if that means thinking outside the box. I have a friend who regularly records his podcast in his car. He lives in a small house with dogs and kids, so there really isn’t anywhere else quiet enough. He takes his laptop and mic out to his driveway, shuts himself in the car and records. The results are surprisingly good!
"The editing process for all our titles starts with receiving the Pro Tools sessions or WAV files and the engineer's script, which has the markings of how many takes there were, and which ones the director liked best. In some cases, I use Strip Silence and add a bed of room tone to expedite the assembly edit. In others I'll add the room tone as I move through the audio. Once I had all the final takes to be used in [Favorite African Folk Tales], I went back to do a fine‑edit pass and created notes on any issues, such as misreads, mispronunciations, noises, and so on. With that list, I was able to discuss with Alfre how we would address the issues. Since the actors' schedules did not permit them to come back in to do pick‑ups I had to do some creative editing.”
Digital Commercials are defined as spots that are used to advertise a product or service that are run on websites or platforms other than the client's own. For example, a 15 second recording that plays on YouTube before the requested content begins. Explainer videos are not included in this rate, they fall into INTERNET USAGE / EXPLAINER in another category.
A demo recording of you doing voice-over work is your CV and your business card combined. If you're applying for a voice-over job, you can send the potential customer your demo via the Internet. Ideally you have multiple demos for different types of gigs. For commercials, clients want to hear 60 to 90 seconds of voice work. If you're auditioning as an audiobook reader, five minutes of demo proves that you can stay in character over a longer stretch of time.

Why the difference in approach? Lots of my e‑learning and corporate jobs are done for production houses that will be adding other voices to the mix. Ironically, if I record my voice via a great mic and preamp, and add some nice processing, it can end up standing out from the other voices, drawing attention to itself. The production house will see this as me causing them a problem, even though my recording sounds better than the others!
"When recording voiceovers at home, you have to focus on performance: keep your energy levels up, stay true to the page, pronounce words correctly and consistently, and make sure you keep to a schedule to make the deadline. Prep well so you don't waste time second‑guessing yourself, looking up words as you go, and remember to not over‑ or under‑direct yourself. Also, make sure you know your recording equipment and room well; being able to quickly make adjustments to mic placement, levels, and so on, will make you more efficient.”
×